|
Title: Drillbit Avalon16 Setup and Restore Post by: addam13rooks on April 08, 2015, 02:38:49 PM Hi guys. Does anyone know how to get the drillbit avalon16 boards out of bootloader? or restored to factory default? My led was on but i pressed the button on the board and its gone out. Im assuming its gone into bootloader mode. Drillbits site has no information at all and i cant get through to them via email. Any information, documentation, instructions or firmware executables would be greatly appreciated :) When i plugged it in before the led went out it was detected as av16 now its detected as ATSAM USB to serial converter :(
Title: Re: Drillbit Avalon16 Setup and Restore Post by: ncsupanda on April 08, 2015, 10:36:55 PM Hi guys. Does anyone know how to get the drillbit avalon16 boards out of bootloader? or restored to factory default? My led was on but i pressed the button on the board and its gone out. Im assuming its gone into bootloader mode. Drillbits site has no information at all and i cant get through to them via email. Any information, documentation, instructions or firmware executables would be greatly appreciated :) When i plugged it in before the led went out it was detected as av16 now its detected as ATSAM USB to serial converter :( When you reset the board what does it do? The LED just stays off? Do you attempt to mine with it? Thanks. Title: Re: Drillbit Avalon16 Setup and Restore Post by: Unacceptable on April 08, 2015, 10:39:15 PM Here's the Drillbit group buy thread,lots of info there,just gotta read it :
https://bitcointalk.org/index.php?topic=266235.0 Title: Re: Drillbit Avalon16 Setup and Restore Post by: addam13rooks on April 09, 2015, 02:11:32 PM Hi guys. Does anyone know how to get the drillbit avalon16 boards out of bootloader? or restored to factory default? My led was on but i pressed the button on the board and its gone out. Im assuming its gone into bootloader mode. Drillbits site has no information at all and i cant get through to them via email. Any information, documentation, instructions or firmware executables would be greatly appreciated :) When i plugged it in before the led went out it was detected as av16 now its detected as ATSAM USB to serial converter :( When you reset the board what does it do? The LED just stays off? Do you attempt to mine with it? Thanks. When i reset the board, im assuming you mean disconnect power and usb and replug it again, it does the same no led. i mined succesfully with cgminer 4.2.2 before the led went out but cant be detected now. :( |