|
Title: Setting up Drillbit Fury Thumb- SOLVED- Now need OC help Post by: pepto on May 10, 2015, 02:13:19 PM Hey all,
This is the Fury Thumb from the original v1.2 group buy, not avalon. The drillbit forum used to have everything I need but it is offline. Even wayback machine can't find it. I used to run it with cgminer and a shortcut that you used as the target. It contained the path, drillbit options, timing, and more. I pretty much need it in cut and paste format as I never really understood it, only that it worked. There were also reset instructions where you crossed a couple of pins until the led flashed differently. Lastly, and not crucial at the moment, there were instructions on overclocking, but getting it running is whats important now. I'll appreciate the help. http://miningbtc.net/wp-content/uploads/2013/12/-2012910372641200.jpg Title: Re: Please help me set up my Drillbit Fury Thumb Post by: pepto on May 11, 2015, 02:47:35 PM Problem, what problem?
Shortcut, timing, options, wut? I installed cgminer 4.9.1, zadig, plugged in the thumb, and crossed my fingers. A lot of share under target going on but it's settling down. I guess it takes a while for solo.ckpool to figure out what it's dealing with. After an hour or so, a best share of 19.6k as confirmed by pool. Pat self on back and thank ck. Title: Re: Setting up Drillbit Fury Thumb- SOLVED- Now need OC Post by: pepto on May 13, 2015, 02:28:23 PM Averaging 2.082Gh/s with a usb fan... and its not even warm.
How do I OC this |
