Title: ZTEX 1.15y: High speed FPGA configuration failed ... Post by: fossil on October 04, 2012, 01:20:53 PM Hi ALL,
I'm running ztex 1.15y cluster. Sometimes the boards disappears. To get it back I pressing r<Enter> in console and the board redetected and restarted. But sometimes I get the messages like " Warning: Error uploading bitstream: FPGA configuration failed: DONE pin does not go high, possible USB transfer errors (INIT_B_HIST=222; 0 bytes got lost): Retrying it ... Warning: Error uploading bitstream: FPGA configuration failed: DONE pin does not go high, possible USB transfer errors (INIT_B_HIST=222; 0 bytes got lost): Retrying it ... Warning: High speed FPGA configuration failed, trying low speed mode:Error uploading bitstream: FPGA configuration failed: DONE pin does not go high, possible USB transfer errors (INIT_B_HIST=222; 0 bytes got lost): Trying low speed mode " Then I go to another console and reprogram that particular board by its id. These messages stop coming to console and the board get redetected successfully or I need to press r<Enter> again to refresh. Q: does anybody know the easier way to get rid of this trouble? With best regards, fossil Title: Re: ZTEX 1.15y: High speed FPGA configuration failed ... Post by: BitcoinINV on October 04, 2012, 01:25:36 PM Does it look like you got any broken welds on the board? check near the FPGA itself.
|