|
Title: A2 hash board versions Post by: mjgraham on December 09, 2015, 06:01:51 PM I have two boards at the moment a green one that says it is official(v3.0) and a blue(20140625) one that has 12 chip pads and 10 chips. What I am wondering what are peoples experiences with these boards? What I have found out so far is the green board has a HW reset ran to the 10 pin connector in pin 1 a low->high will reset board , even though it was not connected at the connector. The blue board has the same thing but will not reset it, looking at it, for some reason it traces out to pin 15 on the MCU which is not the reset but right beside it, it needed to be on pin 14, at little solder bridge seems to fix it. I know the software has a --hwreset which is what toggles this and keeps from a total power down cycle. Anyway what I am noticing if I had an A2 unit that has boards like either one of these , anytime I stopped hashing for any reason I would have to reboot it, is that the case?
Thanks |