Title: "Too many values set to temp curoff." Miner help please, cgminer. Post by: BitCoiner2012 on December 07, 2012, 07:03:25 AM I am only trying to run one card right now, and I am familiar with running CG and reaper, but Ican't underfstand this effort and how to fix it and very difficult for me to find help on net, me and a friend have been working for about five hours I DID get my LTC rig from cplete failure and majorly increased speed.
Please, any help. I will pay LTC or BTC. PM me if you have time to chat or skye for this, I can even call. Title: Re: "Too many values set to temp curoff." Miner help please, cgminer. Post by: crazyates on December 07, 2012, 07:27:08 AM Check your config file, and make sure that you don't have more variables then you do GPUs. I ran into this issue when I would remove a GPU, but not edit my config file.
Example: I downgraded from 3 GPUs to 2 GPUs, but my config file had 3 values for temp-target. CGMiner didn't like that. Title: Re: "Too many values set to temp curoff." Miner help please, cgminer. Post by: segabtc on December 09, 2012, 05:56:00 AM "temp-overheat" : " 95,95,95", something like that 3 card setup
"temp-overheat" : "95,95", to something like this 2 card setup "temp-overheat" : "95", 1 card setup dont forget the comma at the end can change value (95) to any temp you want, i use "85" as overheat EDIT: If this helps, consider a donation to kolivas. dont know his address but look around and i am sure you can find it. Title: Re: "Too many values set to temp curoff." Miner help please, cgminer. Post by: BitCoiner2012 on December 09, 2012, 10:15:15 PM Thanks, this is super great information. I kept getting it from time to time when tinkering, but never could uderstand and I thought it meant I had set settings dangerously high or something.
Appreciate it all the help from this amazing community. |