|
Title: Can't access to TP-link MR3020 device Post by: bunokalpurush on February 01, 2016, 07:31:00 PM I have install the OK_DICE firmware in my TP-link MR3020 device..after installation i can't enter my router by 192.168.0.99
what to do. and how to revers back into tplink original firmware.. I have tried both dhcp i mean dynamic and static..no result... now am afraid am do anything wrong...and brick the device.. after installation complete the device is powered on but i can't access it. I understand that without assessing it i cant restore the original TL firmware is there any other procedure to restore it..?? please give me a help and very thanks for quick reply.. may be i did something wrong.. Thanks In Advanced Fazle Rabbi Bangladesh Title: Re: Can't access to TP-link MR3020 device Post by: notlist3d on February 01, 2016, 07:42:50 PM I have install the OK_DICE firmware in my TP-link MR3020 device..after installation i can't enter my router by 192.168.0.99 what to do. and how to revers back into tplink original firmware.. I have tried both dhcp i mean dynamic and static..no result... now am afraid am do anything wrong...and brick the device.. after installation complete the device is powered on but i can't access it. I understand that without assessing it i cant restore the original TL firmware is there any other procedure to restore it..?? please give me a help and very thanks for quick reply.. may be i did something wrong.. Thanks In Advanced Fazle Rabbi Bangladesh I don't know a lot about that firmware, what miner are you trying to get it to work with? What are you trying dynamic and static on? as it sounds like you cant get to tp device.... so not sure what your changing it on. But if you truly bricked it might need recovered via serial. You might need to get a usb to serial cable, and do a little googling. But it should be recoverable. Title: Re: Can't access to TP-link MR3020 device Post by: pinhead666 on February 01, 2016, 08:11:24 PM What is that fw? Where did you get it from? Should it work with your router? Some useful information please.
Title: Re: Can't access to TP-link MR3020 device Post by: Mitak on February 02, 2016, 12:59:12 AM If you read vendor site
The DICE firmware is DHCP enabled Quote * For DICE version DHCP is enebled by default, when flashing from older technobit img DO NOT KEEP SETTINGS!!!! so look in your router for tp-linkor use some IP_lan _scan tool Title: Re: Can't access to TP-link MR3020 device Post by: Zich on February 02, 2016, 01:21:27 AM If ip scan tool fail, then you need to use serial console.
But, before that, i want to clear some matter first. Do you had more than one network adapter on your PC? Like ethernet port & wireless port. If yes, you need to disable the wireless adapter. You did connect TL-MR3020 using lan cable to your pc right? You will need to make serial adapter using CA42 & open your TL-MR3020 then add some pin on P1. More info: http://wiki.openwrt.org/toh/tp-link/tl-mr3020 http://s26.postimg.org/gf16nkrnt/ca42.jpg (http://postimg.org/image/qp3lmthj9/full/) http://s26.postimg.org/53yiz7ksp/image.jpg (http://postimg.org/image/5thbbklc5/full/) |
