|
Title: Possible issue with Fan speed @ 95-99% Post by: LukeTheMiner on June 19, 2016, 09:06:11 AM I usually don't tinker with the settings with my miners- but i'm going to start keeping my s7's outside and i know the summer heat is going to raise their temperature. To attempt to offset this i'm adjusting my miners to run at 4,000 - 5,760 Rpm. (about 95-99%)
Aside from increased noise/electrical usage- what issues may occur from this change? Title: Re: Possible issue with Fan speed @ 95-99% Post by: philipma1957 on June 19, 2016, 10:48:51 AM do your self a favor
99% = ? rpm 95% = ? rpm 90% = ? rpm 85% = ? rpm 80% = ? rpm run all above for an hour find the exact rpms you may find the speed of 90% is better then 99% for cooling as the wind of the fan flows better over the heat sinks outdoor running is okay if you can protect the gear from moisture. If you find a number like 88% works well use it over 99% Title: Re: Possible issue with Fan speed @ 95-99% Post by: alani123 on June 19, 2016, 11:03:49 AM Hight moisture is extra bad for such machines and in the long term could limit lifespan. There's potential for short term issues as well but that's only if moisture is extra high. So make sure that moisture is sufficiently low where you're going to place your miners.
Title: Re: Possible issue with Fan speed @ 95-99% Post by: -ck on June 19, 2016, 11:22:27 AM Most high RPM fans may well increase their fanspeed and RPM when you go from 85% to 100% but it's been shown that last 15% usually (for high speed fans) only burns more power, makes more noise, but contributes very little to airflow and pressure. It's usually an inefficient part of their power curve. This is not true of lowspeed fans designed to be quiet at low RPMs.
Title: Re: Possible issue with Fan speed @ 95-99% Post by: bitwhizz on June 19, 2016, 06:57:30 PM which issues?
Title: Re: Possible issue with Fan speed @ 95-99% Post by: Tupsu on June 19, 2016, 10:47:51 PM Hight moisture is extra bad for such machines and in the long term could limit lifespan. There's potential for short term issues as well but that's only if moisture is extra high. So make sure that moisture is sufficiently low where you're going to place your miners. which issues? Scrap hash board can not be fixed and warranty will be void https://enforum.bitmain.com/bbs/topics/3510 https://dn-bitmain.qbox.me/o_1al1p96bat1o1j1n1vstf201jsj7.png |
