|
Title: Antminer s9 - dead board advice... Post by: huntingthesnark on February 01, 2017, 12:41:55 PM Hi folks,
so I've got a dead board on one of my S9's. It was previously running well, but I had to move the machine. On reboot one board has no red light on the top (no power? but have double-checked connectors, and isn't hashing. Asic status is only the mid-4, and chip temps are 0. Any suggestions? Can I keep running with 2 boards, and if so is it best to disconnect the dead one from the PSU? Many thanks in advance! Title: Re: Antminer s9 - dead board advice... Post by: HagssFIN on February 01, 2017, 12:48:35 PM Time for warranty repair or fee based repair (Bitmain Warranty in Denver, Colorado).
Title: Re: Antminer s9 - dead board advice... Post by: huntingthesnark on February 01, 2017, 12:53:33 PM I feared that might be the case - can you keep running on two boards though? Like a T9 ;-)
Title: Re: Antminer s9 - dead board advice... Post by: HagssFIN on February 01, 2017, 12:55:27 PM Yes you can run it with two boards. Get in contact with Bitmain to make a RMA case and remove the board and send it properly packed after they say ok.
Here are some instructions, useful to read https://enshop.bitmain.com/workOrderGuide.htm Title: Re: Antminer s9 - dead board advice... Post by: eddiephx on July 30, 2017, 08:17:18 PM Did you ever fix your dead board? Same problem here bro please help me lol
Title: Re: Antminer s9 - dead board advice... Post by: fusion0389 on July 31, 2017, 04:12:32 PM Did you ever fix your dead board? Same problem here bro please help me lol Its not rocket science, just email them and get approval to send the defective unit off for repair. Title: Re: Antminer s9 - dead board advice... Post by: philipma1957 on July 31, 2017, 04:43:58 PM if it is under warranty and you are usa based they opened a center in los angles
you do not have to ship it to china. |