|
Title: antminer d3 with ATX psu Post by: thesavoyard on September 27, 2017, 06:34:51 AM I'm using a Lepa 1700w Platinumax. I pulled this from my GPU miner when I switch to dual PSU and it worked fine. I hooked up all 10 six pin connectors. I bridged the green wire with the black next to it but nothing. I've switched it between various adjacent black wires and still nothing. The fan did power up for about 15 seconds once when unplugged and power switch off. Must have been running on capacitor power.
Any ideas? The PSU should have load from the Antminer if it works. Title: Re: antminer d3 with ATX psu Post by: thesavoyard on September 27, 2017, 07:04:57 AM Nevermind I got it, the contacts inside the plug are tiny apparently, I made a needle short that presses against them. Had to do it with power on to see when it made contact, lucky I didn't get a jolt lol.
|