Bitcoin Forum

I have 13 Avalon 6's. I use a raspberry Pi as the controller. Everything works perfectly and gives lights that say everything is working but in the software it says that zero modules are alive. I cannot get the miners to mine anything.

How many AUC cables do you have connected to the Pi?

Does it work if you connect just one? (Then add another until it fails)

only one for now. Once I get one to work I will plug in the rest

Does it work when you connect one AUC to one A6?

No, it does not. That is what I am trying to do. I have one miner hooked up to one AUC2 adapter hooked up to one Pi being used as a controller

Is the Pi hooked up to the internet? Can you post screens of your status pages?

Is this what you were asking for?

I can see your settings and your static IP set on the Pi, but is that actually online? If you SSH into the pi, can you ping www.google.com, or use curl on it?

With my Avalon controller, I just set it to DHCP so I know it gets an address from my router.

I just tried it and it says that ping: bad address and then lists the address I put in. I put in "www.google.com"

Change the controller from Static IP to DHCP. It's not actually on the internet. Be sure to change your laptop back to DHCP too and reconnect with the new IP - connect to your router to see what IP the controller got.

I changed it to DHCP, and looked on my router, but it only lists my laptop as on the network and now I can't get back into the controller.

I GOT IT! Thanks a bunch my guy!!!!!

I am using the same setup but I have another batch of miners set up at a different location. Everything is hooked up (It is set to DHCP correctly) I made sure it is connected to the internet but it shows zero alive modules. Help?