Title: Anchoring my riser board Post by: rwtrader on November 06, 2017, 10:41:05 PM Some of the small boards that go into the 1x pcie slot are a little loose where it only takes a small bump on the cable to kick a gpu offline. I was trying to find a way to anchor it to the mobo. I see a small hole in the circuit board that could be used to tie it to something, but I am not sure what. Any ideas? Any experience with this? Thanks for any help!!
Title: Re: Anchoring my riser board Post by: leonix007 on November 06, 2017, 11:24:40 PM Some of the small boards that go into the 1x pcie slot are a little loose where it only takes a small bump on the cable to kick a gpu offline. I was trying to find a way to anchor it to the mobo. I see a small hole in the circuit board that could be used to tie it to something, but I am not sure what. Any ideas? Any experience with this? Thanks for any help!! Try to replace the riser, I bet its the riser that is not fitted well into 1xPCIE, otherwise insert a little piece or rubber just enough to hold the riser into slot. Title: Re: Anchoring my riser board Post by: Phantoms001 on November 07, 2017, 04:20:27 AM That is interesting. Maybe a cheap riser? Most of mine feel pretty snug. Maybe its a board thing. They have a hook at the end that kind of holds them in place.
I guess I would try a small piece of duct tape over the top to the sides of the PCIe slot. Title: Re: Anchoring my riser board Post by: Za1n on November 07, 2017, 05:01:15 AM I don't know where the post is, but I do remember reading some time ago about a guy who came up with a little clip to secure the mining riser board to the slot using a 3D printed part. He was selling the plans for a few dollars, and I believe he was even selling the clips. If you want to do it cheaply you could probably just use some electrical tape to secure it to the slot.
EDIT: Found a plan if you or a friend has access to a 3D pritner. https://www.thingiverse.com/thing:2627344 (https://www.thingiverse.com/thing:2627344) Title: Re: Anchoring my riser board Post by: patofet on November 07, 2017, 07:25:47 AM Some of the small boards that go into the 1x pcie slot are a little loose where it only takes a small bump on the cable to kick a gpu offline. I was trying to find a way to anchor it to the mobo. I see a small hole in the circuit board that could be used to tie it to something, but I am not sure what. Any ideas? Any experience with this? Thanks for any help!! There are mobos with ancors to do this, but you can print it |