Bitcoin Forum

Bitcoin => Hardware => Topic started by: candoo on July 05, 2013, 05:49:57 PM



Title: Avalon Voltmod?
Post by: candoo on July 05, 2013, 05:49:57 PM
Hey folks,

is there any way to give the chips more Volt? (I know there is much more needed then air cooling).

I get lots of HW errors with a frequency higher then 365 and I think they need a little bit more volts!.

The temperature of the chips is only at 45-50°C! (max is 70 in the chip spreadshet) so I could give him a bit more overclocking.


Title: Re: Avalon Voltmod?
Post by: Keninishna on July 06, 2013, 12:07:43 AM
The only problem is everyone is too scared to fry their precious avalon chips.


Title: Re: Avalon Voltmod?
Post by: fasmax on July 06, 2013, 12:45:34 AM
I think the real problem is the regulator chip is only rated at 20 amps.
So I don't think increasing the voltage will help much or not at all.
But to answer your question.
The resistor at R10 is a 10.5K ohm resistor if you were to replace it with a 10.0k ohm resistor you would increase the voltage a few hundredths.
I suspect Avalon has already found that the 10.5K ohm resistor is the best value to use it sets the voltage at about 1.15 volts.