|
Title: Question About Wire For PSU (AWP3++) Post by: MMMining21 on December 18, 2017, 01:24:15 AM Hello everyone, i'm currently using a wire king-cord (10A and 120V) for the AWP3++ of my antminer s9. I was wondering if its safe, or should i get a bigger wire ? Thank you
Title: Re: Question About Wire For PSU (AWP3++) Post by: cableiso on December 18, 2017, 03:17:54 AM Get a bigger one, 15A. But APW3 can't run an s9 on 120V anyway unless you are only using 2/3 boards.
Title: Re: Question About Wire For PSU (AWP3++) Post by: MMMining21 on December 18, 2017, 12:16:38 PM Get a bigger one, 15A. But APW3 can't run an s9 on 120V anyway unless you are only using 2/3 boards. Thank you for responding, so 15A would be the ideal, how about the Volt now if 120 isnt enough? Thank you Title: Re: Question About Wire For PSU (AWP3++) Post by: HagssFIN on December 18, 2017, 12:19:58 PM Bitmain APW3++ power supply can only provide 1200 W power capacity when the mains voltage is 110-120V.
You need 220V voltage if you want to run a S9 with one APW3++ power supply. Otherwise you will need to power two hash boards with the APW3++ and have another good power supply powering the third hash board and the controller. If you do this, be sure that you don't mix two psus together in a same hash board, and power on the one connected to the controller last. Title: Re: Question About Wire For PSU (AWP3++) Post by: MMMining21 on December 22, 2017, 03:56:03 AM Bitmain APW3++ power supply can only provide 1200 W power capacity when the mains voltage is 110-120V. Thank you very much!You need 220V voltage if you want to run a S9 with one APW3++ power supply. Otherwise you will need to power two hash boards with the APW3++ and have another good power supply powering the third hash board and the controller. If you do this, be sure that you don't mix two psus together in a same hash board, and power on the one connected to the controller last. |