|
Title: PCI riser assembling info Post by: kakoluckiam on January 12, 2018, 12:07:52 PM Hi there.
So, here is the pic http://i65.tinypic.com/102ov35.jpg My riser arrived with this black gum glued on their bottom side. I tryed to indicate them on the pic with the red arrows. Do I have to remove those or are they made to stay there? Because if I remove them, the bottom side with be touching my aluminium frame, and I don't think that's a good thing. Title: Re: PCI riser assembling info Post by: Thekool1s on January 12, 2018, 12:16:41 PM Just leave them there.. It will act as backplate for them.
Title: Re: PCI riser assembling info Post by: gt_addict on January 12, 2018, 01:57:46 PM Its there to stop the pins shorting out on metal frames.
Title: Re: PCI riser assembling info Post by: jmigdlc99 on January 12, 2018, 02:09:13 PM Over time, that "black gum" glue thing will eventually peel off because of all the heat being generated by your mining rig. Like the previous poster said, its there to help keep you from accidentally shorting your rig. Even if you're not using metal frames just leave it on there because it adds protection to your riser. GPUs aren't that heavy but over time your bare risers pressing on anything hard will eventually either deform the surface its placed on or will break the riser pins at the botoom.
|
