Title: Using Stratum Proxy, Constantly 'Asks for more work; !? Post by: Tomtheman2 on September 07, 2013, 06:02:04 PM Hi,
I have my ASICMiner blade set up and running on Slush's pool. Working all fine and everything but I have noticed it 'Asks for more work' a lot more than it does actually submitting work. What gives? Also, for the first 2 hours, my blade was running at around 10gh/s, now its at 7hg/s ish. Changing the clock to High doesn't change anything also. Can someone help me out? By the way i'm on a Mac so not running any software. Cheers! Title: Re: Using Stratum Proxy, Constantly 'Asks for more work; !? Post by: HellDiverUK on September 07, 2013, 07:26:13 PM Tried a different pool for an hour? See if it's your setup, or slush's pool that's at fault?
Title: Re: Using Stratum Proxy, Constantly 'Asks for more work; !? Post by: Ridicuss on September 07, 2013, 08:01:24 PM Hi, I have my ASICMiner blade set up and running on Slush's pool. Working all fine and everything but I have noticed it 'Asks for more work' a lot more than it does actually submitting work. What gives? Also, for the first 2 hours, my blade was running at around 10gh/s, now its at 7hg/s ish. Changing the clock to High doesn't change anything also. Can someone help me out? By the way i'm on a Mac so not running any software. Cheers! When you say your blade was running 10GH/s and now 7GH/s, is that the config page reported hashrate or the rate reported from Slush? After you select high clock do you reboot the blade? Title: Re: Using Stratum Proxy, Constantly 'Asks for more work; !? Post by: Tomtheman2 on September 07, 2013, 09:29:12 PM Cheers for the reply. Did exactly that, switched to another pool now switched back and now it's fine.
Hashrate seems to be normal now. Cheers for the help guys. |