|
Title: AsicBlade miner all X on chips Post by: b0t on September 22, 2013, 06:03:50 PM Hello,
I've just received new AsicBlade (10-13GH/s). I set up it according to https://bitcointalk.org/index.php?topic=205369 (https://bitcointalk.org/index.php?topic=205369) guide on this forum. I was working fine for about 8 hours. After that I see in web configuration all X on the chips. I was using 220W PSU with 14A on 12V line. After that i tryed another PSU (350W, 14A on 12V) -- without change. I was measuring voltage on H2R2 and i had 1.065V, I tryed change it to 1.15, without change. Blade is running (it produce heat, web interface is running, but it is not hashing, all "x" on chips). If blade is connected, between yellow(+) and Black(-) Cable is around 11.12V, without blade 11.89. Is it too low? Should I try with "better" PSU which gives really 12V? Is this wrong? Thank you for your answers. |