|
Title: Avalon blinking power light message? Post by: smoothrunnings on September 27, 2013, 06:04:57 PM Is there a list of messages for the blinking power light on the Avalon miner?
I have a B1 box, the power light blinks, it's green, the temp on #2 shows up as -1. I suspect the cable came lose when I replaced the PSU on it or when I was trying to put the lid back on it. Thanks. Title: Re: Avalon blinking power light message? Post by: Dalkore on September 27, 2013, 06:39:35 PM Is there a list of messages for the blinking power light on the Avalon miner? I have a B1 box, the power light blinks, it's green, the temp on #2 shows up as -1. I suspect the cable came lose when I replaced the PSU on it or when I was trying to put the lid back on it. Thanks. Does it mine steady while the blinking is going on? Title: Re: Avalon blinking power light message? Post by: smoothrunnings on September 27, 2013, 06:51:07 PM Is there a list of messages for the blinking power light on the Avalon miner? I have a B1 box, the power light blinks, it's green, the temp on #2 shows up as -1. I suspect the cable came lose when I replaced the PSU on it or when I was trying to put the lid back on it. Thanks. Does it mine steady while the blinking is going on? Yes it mines without stopping so far. I upgraded the PSU from 650 to 860 watts. I also noticed on this website that had the info for the B1 Avalon that its picture of mining in process shows the temp2 also at -1, so I wonder if what I am seeing is normal? http://en.qi-hardware.com/wiki/Avalon Title: Re: Avalon blinking power light message? Post by: Dalkore on September 27, 2013, 08:12:41 PM Is there a list of messages for the blinking power light on the Avalon miner? I have a B1 box, the power light blinks, it's green, the temp on #2 shows up as -1. I suspect the cable came lose when I replaced the PSU on it or when I was trying to put the lid back on it. Thanks. Does it mine steady while the blinking is going on? Yes it mines without stopping so far. I upgraded the PSU from 650 to 860 watts. I also noticed on this website that had the info for the B1 Avalon that its picture of mining in process shows the temp2 also at -1, so I wonder if what I am seeing is normal? http://en.qi-hardware.com/wiki/Avalon I have gotten the "-1" reading without it affecting the hashing operation. As long as it is hashing normally I would not be too concerned at this point. Title: Re: Avalon blinking power light message? Post by: bobili on October 01, 2013, 08:18:19 PM Is there a list of messages for the blinking power light on the Avalon miner? I have a B1 box, the power light blinks, it's green, the temp on #2 shows up as -1. I suspect the cable came lose when I replaced the PSU on it or when I was trying to put the lid back on it. Thanks. have you update with new firmware.... Mine is blinking red on update off new firmware and it is oK as software developer saiz....Loading hash or something... But if your machine works fine not restarting or so....Don't worry....just hashing...:) |