|
Title: BitSend Mining Post by: dll70dll on March 16, 2018, 06:08:27 PM Hello all
- I was looking into mining Bitsend on GPU's I have tried it on Suprnova and it's finally confirmed my transaction. Here is the problem I am running into now! My test system has 1 1080 rig in and works getting stock settings 3684kH/s but when I move it over to my 4 card system 1080's it starts out ok at about 3000kH/s but then drop down to 15mH/s per card. Using the exact same bat file ccminer -a xevan -o stratum+tcp://bsd.suprnova.cc:8686 -u DLLAMKE70.PC1080 -p x What is happening here and Why Any help would be much appreciated Thanks - Title: Re: BitSend Mining Post by: jillscarbrough on March 19, 2018, 09:27:01 AM So, your hashrate was drop. My question, where you see that your hashrate was drop? In ccminer or pool stat? If you see that's on software client, mean trouble was on the system or cards itself. On pool, it's normal.
Title: Re: BitSend Mining Post by: dll70dll on March 22, 2018, 12:43:40 PM No it working correctly.
- My bad did not notice till after I had gone to work on break remote stop and switch to back up miner. Than that next day notice my wallet had received some coins. The sites to track the mining are not updating right away and take up to 289 confirmations needed before comfired. using www.lycheebit.com (http://www.lycheebit.com) and Suprnova.cc (http://Suprnova.cc) as my primary Anyways looking that morning notice something funny after I sat at my pc looking at the numbers. the 15mH/s is total for all 4 cards and that would work out to about 3684kH/s Very new at mining. getting my rigs setup Late to the game but in for the long hall DLL Title: Re: BitSend Mining Post by: DENDOGODNED on March 22, 2018, 01:18:41 PM Hello all - I was looking into mining Bitsend on GPU's I have tried it on Suprnova and it's finally confirmed my transaction. Here is the problem I am running into now! My test system has 1 1080 rig in and works getting stock settings 3684kH/s but when I move it over to my 4 card system 1080's it starts out ok at about 3000kH/s but then drop down to 15mH/s per card. Using the exact same bat file ccminer -a xevan -o stratum+tcp://bsd.suprnova.cc:8686 -u DLLAMKE70.PC1080 -p x What is happening here and Why Any help would be much appreciated Thanks - chances are its not your rig but the mh/s coming into the pool. did you check to see what difficulty comes up with one card then check what difficulty the pool throws at you when coming in with 4 cards? That will make a difference to your mh/s . you can try adjusting it although im not sure if you can with that pool or algo but its work a try . instead of -p x try -p d=6 or whatever you like try experimenting you should get some crazy results but if it works . just dont go to low or to high ok i tryed it and d= wont work but you can try -m 40 or experiment with that number mayby -m 200 . |