|
Title: Restoring Bitmain Firmware (V9, T9+, others) Post by: DaveF on March 22, 2018, 01:29:14 AM There have been some posts about loosing connections to the V9 miner.
Also some people have had issues with the new T9+ If you take a look here: https://shop.bitmain.com/support.htm?pid=007201604120945219855QObfk20066C (https://shop.bitmain.com/support.htm?pid=007201604120945219855QObfk20066C) You can get the downloads to burn a SD card to restore your firmware. ***The T9+ is not the same as the T9*** If you put the wrong firmware on you will probably own a paperweight. -Dave Title: Re: Restoring Bitmain Firmware (V9, T9+, others) Post by: longman77 on June 28, 2018, 03:50:50 PM Here are the files from the above posted link.
Which are needed on the SD Card? If S2S4S5S7-img is one of the needed files and the V9 .tar is the other is it a two step process? That is burn the S2S4S5S7-img first then on another SD card run the .tar file ???? or can you just put all the files on one SD card and let it run? These two files from Tools and Instructions to Image SD card DiskImager Application 88 KB S2S4S5S7-img Disk Image File 512,000 KB ------------------- Antminer-V9-20180312-600M.tar gz Archive 16,459 BOOT.bin BIN file 2.688 KB devicetree.dtb DTB file 8 KB uImage File 3,762 KB uramdisk.image gz Archive 12,441 KB Title: Re: Restoring Bitmain Firmware (V9, T9+, others) Post by: BitMaxz on June 28, 2018, 05:51:24 PM If you put a wrong firmware it can result of deadboot or it can brick your miner without any software solution.
You must put a correct firmware for t9+ How about using this firmware from here https://shop.bitmain.com/support.htm?pid=007201802091434313565J4tI3p60644 and use the sd card tool to make a sd card bootable and put the firmware inside the sd card? Title: Re: Restoring Bitmain Firmware (V9, T9+, others) Post by: longman77 on July 01, 2018, 01:39:03 PM I think after much reading I know the sequence.
Note in DaveF link above there is a V9 version of the firmware. So first you download v9-SD Tools.zip Then unzip that and get : DiskImager Application 88 KB and S2S4S5S7-img Disk Image File 512,000 KB Then - using the Diskimager program - you put the S2S4S5S7-img file onto your SD Card. Then load the SD card software into your miner on a startup. With luck you should end up with a miner that will get into the normal miner program. Then using the update function from within the miner you update with Antminer-V9-20180312-600M.tar which you should have downloaded to your computer previously. The only file that ever gets put onto the SD card is the S2S4S5S7-img Disk Image File I would feel better if the name of this file included V9 but the title does say v9-SD Tools.zip The main software ( Antminer-V9-20180312-600M.tar ) gets updated from within your computer NOT the SD Card. At this point I am not ready to try this so cannot say it works. Use at your own risk! Comments please if you think this is the correct method or is a wrong method. There seems to be very little info available on how to use the SD Card. Maybe they think it is so easy us newbies should already know. |