Title: Question about asic blade v2 Post by: Dunpeal on November 05, 2013, 02:13:40 AM I just received the version 2 asic blade, its the green pcb board and it has the fuse soldered on to the board instead of a SMD fuse, I have both the green and blue pcb board and the blue one works perfect no problems, the new asic blade does not turn on everything is wired properly, I tested the contacts and it shows 12v, but I have no idea where else to start on the unit, kind of fustrating, I even disconnected the old asic blade thought maybe not enough juice, and still no lights on the network port, could anyone help me out?
The one i am referring to is this one http://cashinbitcoins.com/wp-content/uploads/2013/10/-351861812499730830.jpg I honestly dont know where to start. Remember I do have one that works plugged the new one in and does not work, possible faulty? Title: Re: Question about asic blade v2 Post by: ooxtcoo on November 08, 2013, 10:23:17 PM I just received the version 2 asic blade, its the green pcb board and it has the fuse soldered on to the board instead of a SMD fuse, I have both the green and blue pcb board and the blue one works perfect no problems, the new asic blade does not turn on everything is wired properly, I tested the contacts and it shows 12v, but I have no idea where else to start on the unit, kind of fustrating, I even disconnected the old asic blade thought maybe not enough juice, and still no lights on the network port, could anyone help me out? The one i am referring to is this one http://cashinbitcoins.com/wp-content/uploads/2013/10/-351861812499730830.jpg I honestly dont know where to start. Remember I do have one that works plugged the new one in and does not work, possible faulty? you need a multimeter. check vrm voltage, should be 1,05 volt on all 8 lines. is the green led blinking when you connect power to the board? if not, maybe fuse i demaged or maybe one asic is demaged and make short. i had same problem, i have 2 demaged blades, they started to get demaged asics.. both near the same time and i dont know why. i desoldered asics from my block erupter usb sticks and soldered it into the blade.. now my blades are back working, but now i have lost 16 usb erupters for the asics. if you cant get it working, i would be interessted to buy your demaged blade. |