|
Title: I need someone with PCB design experience - looking to use bitfury chips Post by: klondike_bar on November 09, 2013, 10:29:45 PM Im looking for someone with a bit of EE design and eagle experience to help bring my ideas to fruition. I would like to produce h-boards for v2 style m-board since bitfury has held over new sales for at least a few weeks coming.
it would be nice to develop a 12 or 16-chip design with a trim pot that can be adjusted from the side (ie: while the unit is in operation) rather then from the front like the v3 boards use. it could be an open design or whatever is needed, the main focus would be to enable these to be produced sooner and cheaper than bitfury is bringing to market, and ensure that v1/2 m-boards can continue to be upgraded if BFSB/MBP discontinue support Title: Re: I need someone with PCB design experience - looking to use bitfury chips Post by: bobsag3 on November 09, 2013, 10:45:42 PM Im looking for someone with a bit of EE design and eagle experience to help bring my ideas to fruition. I would like to produce h-boards for v2 style m-board since bitfury has held over new sales for at least a few weeks coming. I might be able to point you in the right direction, shoot me a PM. it would be nice to develop a 12 or 16-chip design with a trim pot that can be adjusted from the side (ie: while the unit is in operation) rather then from the front like the v3 boards use. it could be an open design or whatever is needed, the main focus would be to enable these to be produced sooner and cheaper than bitfury is bringing to market, and ensure that v1/2 m-boards can continue to be upgraded if BFSB/MBP discontinue support |