Title: Blade Rev. 2.01 not mining Post by: ZBC3 on November 14, 2013, 02:15:08 PM My blade v 2.01 has been working fine since September. However, yesterday the chip went to xxxxxxxooooooxxxxxxxxx, and was reporting a hash rate of 24 ghz using 550 PSU. I tried resetting with 1&2, and 2&3 and now the configure page is not working. The yellow & green led's are flashing on the cat5 connector and the green led below the cat5 connector flashes when I power on the blade. Any suggestions as to why I can no longer access the configuration page?
Title: Re: Blade Rev. 2.01 not mining Post by: vm1990 on November 14, 2013, 08:48:37 PM id try changing the ethernet cable if that dosnt work its more than likely a power supply problem
|