|
Title: ASICs don't seem to be registering "correct" hash rate on pools Post by: tonto on December 03, 2013, 10:22:39 PM So I'm wondering if someone might offer some advice, please?
I'm using bfgminer version 3.8.0 and connected to slush's pool. I'm using the following settings on on the command line: Code: bfgminer.exe -o stratum.bitcoin.cz:3333 -u myminer -p mypass -S all When I check my account status on their web page, it's saying I'm only mining at roughly 300Mhash/sec. It should be roughly 40Ghash (two jalapeņos and one little single). This also appears to be the same result on btcguild.com as well. The bfgminer app shows that I'm hashing normally, i.e. 15GHash for the 2 (upgraded) jalapeņos and the 1 little single (25GHash). So I don't know if I need different flags or a different server or port or what. Anyone have any suggestions on where I'm going wrong? I've found various snippets of information on the web, but lots of conflicting info, which might be dependent on the miner and version. Title: Re: ASICs don't seem to be registering "correct" hash rate on pools Post by: vm1990 on December 03, 2013, 11:31:37 PM slushes pool does take along time to register the correct hash rate due to the way its registers shares
Title: Re: ASICs don't seem to be registering "correct" hash rate on pools Post by: tonto on December 04, 2013, 12:18:30 AM Ok thanks for the info. Should I assume that I'm hashing at the correct rate, then, and should hopefully be compensated accordingly? :)
Title: Re: ASICs don't seem to be registering "correct" hash rate on pools Post by: vm1990 on December 04, 2013, 10:33:53 AM if your miner says your hashing a x speed and aslong as you not getting to many stales, rejects, hw errors it will be recording the correct speed. it normaly takes 6 or so hours maybe upto 24 but it will get up to full speed
|