Bitcoin Forum

Hi to all

i'm totally new to this so bare with me.

First off all the setup:

Gigabyte M/B
1x ATI 6990 (with the switch in position 2)


After fighting with the Gigabyte M/B i finally booted the Linuxcoin final.
i did the ATI SDK Licence
and the apt update.

So now i want to start mining.
So far I only got GUIMINER to start mining but it only uses one GPU.
The options that GUIMINER gives me are 0-0 Cayman, 0-1 Cayman and the CPU

I started mining using 0-0 Cayman and it was hashing 330 Mhash/s  and the ATI Temp was more than 90 C!!!
I try to open a new miner under 0-1 Cayman but it was not doing anything.

Then i try using hashkill.
I try to tar the file located at /opt/miners and the run sudo ./install.sh but i got an error.
I try to do ./configure and make but after running make it gives me an error
when i try apt-get install hashkill it says that it is already installed.

So then i try to run hashkill  but it says that plugin is missing.

It would be great if someone could give me any help because for the last 12 hours i read all over the forums various posts but i can not figure out what the problem is.


Thanx

Please give some specifics on the errors.  Do the install again, cut & paste everything and I'm sure someone will be able to help.

root@linuxcoin:/opt/miners# sudo ./install.sh

sudo: ./install.sh: command not found


This is what i get

UPDATE

after more searching i finally get hashkill to run.

I erased the hashkill tgz under /opt/miners
i downloaded again using wget
and the install was succesfull

Then i just set the LD_LIBRARY_PATH

and bang!!!!!!!!!

Right now it gives me 702 Mhashes/sec and the temperatures are 78C and 71C.

eff 85%

stale:10
submitted: 262


What do you think about my stats ?????

Can i do better?

got it up to 778 Mhashes/s

does anyone has any input on if it is possible to get to this https://bitcointalk.org/index.php?topic=25798.0  using Hashkill?