|
Title: Can I flash a Avalon Batch 2 through USB? Post by: snerp on December 22, 2013, 04:00:29 AM I just picked up an Avalon Batch 2 with a faulty NIC. Is there any way to flash the firmware? I'd like to OC it.
I've ran a few searches without any luck. Title: Re: Can I flash a Avalon Batch 2 through USB? Post by: SolarSilver on December 22, 2013, 04:53:16 PM I just picked up an Avalon Batch 2 with a faulty NIC. Is there any way to flash the firmware? I'd like to OC it. I've ran a few searches without any luck. depending on how it's set up (you can do a factory reset), you can connect over wifi. This will allow you do do the configuration and connect it over wifi to the internet. If the TP-LINK board is defective, you can either replace it or run the USB cable direct to another host running cgminer (look at it's thread for details) thus using the 3 modules at 85+ GH/s |