|
Title: Help Regarding a Block Erupter Setup Post by: Zulfe on December 26, 2013, 09:27:24 PM Hello, I'm trying to setup an ASICminer Block Erupter I recently purchased. I have CGminer 3.7.2, and I can't figure out how to get it to run properly.
I had it working on 3.1.1 CGminer, but I couldn't get any blocks; they all reported an error saying that the block was share was above the target. I'll run it again to give more exact details directly from CGminer. Has anyone else had this problem, and is there something I'm doing wrong in 3.7.2 to set it up. I've installed the Silicon Labs driver for the device, and it has a valid COM ID. |