Title: ASIC Blade displays 'xxxxxxxx' after 2-3 months of solid hashing Post by: wtiger127 on January 15, 2014, 09:50:57 PM Hello,
I am looking some help on the following... I have 2 ASIC mining Blade from first Gen which are comprised of network, hash chips and heat seek pieces that come together. For the past 2-3 months the blades have been running with no issues at all and hasing between 10500 and 11800. ISSUE Just 2 nights ago, I lost one of the blades from hashing as it displayed 'xxxxxxxxx' instead of 'ooo' or ' OOO' across the top. I can get to the web GUI and make changes and what the timer tick away. But I don't see the hash rate return at all. I cut up a new power cable and conected to the blade thinking this could be lack of power to the device...and still nothing. I also used a meter to see how much power the unit is receiving and I see it gets just 1.19v. The other is the same. I also reset the board by using a paperclip to the reset pins near the "mormal 1-2' and reset. This did wiped the IP address etc but the 'xxxx' still remained before and after. Not sure whatelse I should be doing since the only support manual was a 1 page showing a diagram how to connect all pieces. Can any one provide some assistance. PS: I am asking here instead of "dogie's" post ([Guide] Dogie's Comprehensive ASICMiner Blade Setup) because my account still shows new and have no other way to reply to his post "https://bitcointalk.org/index.php?topic=205369.1260" which may have the answer I am looking for. Maybe someone can repost to Dogie's ??? Thank you very mych... |