|
Title: BitBurner Fury Question Post by: GayEddie on February 16, 2014, 02:35:42 PM Hello All
I bought a 2 stacked bitburner fury boards they were used. I can not seem to get any life out of them. Now I have bought a cheap PSU but I thought it would not matter but when I plug in, the fans dont even come on or any lights. Title: Re: BitBurner Fury Question Post by: CaptEmulation on March 06, 2014, 10:49:01 PM What power supply are you using? Aer the boards chained together?
I managed to burn one board with crossed power lines :'( and it exhibits the same symptoms-- no response whatsoever to power. Title: Re: BitBurner Fury Question Post by: Skaterdiejosh on March 07, 2014, 05:11:07 PM Yeah from my experience with old erupter blade cards I used to mine with if you put power to the boards with reverse polarity it burns the card up . You have to replace some kind of little fuse that solderd into board .. If you have a good fluke voltage meter u can check it out . Put it on resistance mode that looks like a ohm symbol. Put the two leads across the power connection points on the board (+ -). If it dont read any value on the meter then you fucked it up .......
|