Title: new rig, cudaminer runs fine for 1 min then explodes Post by: wuzamarine on February 16, 2014, 05:34:56 PM I have twin tesla k10s on and ASUS z87-plus board. No obvious errors. I start cudaminer with -> cudaminer -H 2 -i 0 -l auto -C 1 -o stratum+tcp://mining.updamoon.com:9008 -O tunae.tunae:1 and after a few seconds I get;
[2014-02-16 12:31:25] GPU #0: Tesla K10.G1.8GB, 164.70 khash/s [2014-02-16 12:31:25] GPU #2: Tesla K10.G1.8GB, 121.44 khash/s [2014-02-16 12:31:25] GPU #1: Tesla K10.G1.8GB, 135.55 khash/s [2014-02-16 12:31:25] GPU #3: Tesla K10.G1.8GB, 180.60 khash/s [2014-02-16 12:31:26] accepted: 1/1 (100.00%), 602.29 khash/s (yay!!!) [2014-02-16 12:31:28] GPU #1: Tesla K10.G1.8GB, 244.07 khash/s [2014-02-16 12:31:28] accepted: 2/2 (100.00%), 710.81 khash/s (yay!!!) [2014-02-16 12:31:28] GPU #3: Tesla K10.G1.8GB, 218.36 khash/s [2014-02-16 12:31:28] accepted: 3/3 (100.00%), 748.57 khash/s (yay!!!) And we think we are rolling! Then, after about a minute, i get; [2014-02-16 12:33:16] GPU #1: cudaError 30 (unknown error) calling 'cudaMemcpyAsync(context_idata[stream][thr_id], X, mem_size, cudaMemcpyHostToDevice, context_streams[stream][thr_id])' (salsa_kernel.cu line 923) [2014-02-16 12:33:16] GPU #1: cudaError 30 (unknown error) calling 'cudaStreamWaitEvent(context_streams[stream][thr_id], context_serialize[(stream+1)&1][thr_id], 0)' (salsa_kernel.cu line 931) [2014-02-16 12:33:16] GPU #1: cudaError 30 (unknown error) calling 'cudaEventRecord(context_serialize[stream][thr_id], context_streams[stream][thr_id])' (salsa_kernel.cu line 937) And I have to reboot to recover. Any thoughts? Title: Re: new rig, cudaminer runs fine for 1 min then explodes Post by: Lizzardis on May 10, 2014, 02:19:42 PM To be fair, I'm bumping this thread because I'm now suffering from the same problem. My KFA2 GeForce GTX 750 Ti is suffering from the same issue. When I've overclocked it to run at ~300Kh/s, it reports the errors the same as OP above, yet when it runs at ~260Kh/s, it runs fine. Only trouble is.. I'm losing out on those 40Kh/s and I'd rather not.
I know my GTX 750 Ti can do ~300Kh/s it's just this error keeps stopping it. Any help? Title: Re: new rig, cudaminer runs fine for 1 min then explodes Post by: djm34 on May 10, 2014, 02:35:53 PM ask the question in cudaminer thread
|