|
Title: Fake fan sensor problem.. need advice. Post by: Tenjin on August 17, 2019, 02:50:01 PM Anyone know where can I get the Whatsminer M3 custom firmware that can ignore the fan speed check? Or I can only use the fake fan rpm sensor for immersion. Thanks for the advice.
Title: Re: Fake fan sensor problem.. need advice. Post by: DaveF on August 17, 2019, 07:47:05 PM Anyone know where can I get the Whatsminer M3 custom firmware that can ignore the fan speed check? Or I can only use the fake fan rpm sensor for immersion. Thanks for the advice. 2) This question comes up a lot. https://www.techidiots.net/notes/fake-fan-sensor (https://www.techidiots.net/notes/fake-fan-sensor) If you are going to do an oil immersion just do a quick board like that. There are a few on pre-made ones ebay and other places. -Dave Thank you Dave. I've seen this page before. The only thing I curious about is the M3 control board has 3pins slot. If I plug in the fake fan RPM sensor, will it be working like antminer S9. https://imgur.com/TIriaM9 I've post new thread in the Mining support section and will delete this one soon. Thanks mate. As far as I know it will be fine, if you look at the picture it's just 3 wires. + and - and speed https://www.techidiots.net/pictures/projects/fake-fan-sensor/20150213-213225.jpg (https://www.techidiots.net/pictures/projects/fake-fan-sensor/20150213-213225.jpg) -Dave Title: Re: Fake fan sensor problem.. need advice. Post by: Tenjin on August 18, 2019, 03:02:02 PM Thanks Dave. ;)
|