|
Title: ANTMINER S9 How to off two hashboard ??? Post by: cashnetkwk on December 09, 2019, 11:46:52 PM Hello everyone
Is it possible a put off two hashboard in Antminer s9 and works only one Huh? Title: Re: ANTMINER S9 How to off two hashboard ??? Post by: miner29 on December 10, 2019, 03:54:55 PM Try removing the data cable and power cables. (turn it off first)
To the hash boards you dont want running. Title: Re: ANTMINER S9 How to off two hashboard ??? Post by: cashnetkwk on December 10, 2019, 05:11:43 PM I try this earlier :( This is don work :( The Antminer cannot connect to the pool,when the cable of 2 hashboard a turn off
Do you have any idea ? Title: Re: ANTMINER S9 How to off two hashboard ??? Post by: crairezx20 on December 10, 2019, 06:04:59 PM Switch the firmware to braiins OS and do the suggested above again.
The suggested above should be work because bitmain has a guide that you need to test the hashboard one by one so it means it should run even one hashboard. You might be have a faulty hashboard that is why you are getting error when running one hashboard. Try to use Braiins OS or check your Ethernet connection. Title: Re: ANTMINER S9 How to off two hashboard ??? Post by: huntingthesnark on December 11, 2019, 05:19:28 PM Switch the firmware to braiins OS and do the suggested above again. The suggested above should be work because bitmain has a guide that you need to test the hashboard one by one so it means it should run even one hashboard. You might be have a faulty hashboard that is why you are getting error when running one hashboard. Try to use Braiins OS or check your Ethernet connection. S9's should run fine on any number of boards, suggest testing each one in turn to find the dead one. Title: Re: ANTMINER S9 How to off two hashboard ??? Post by: lightfoot on December 19, 2019, 02:29:04 PM True: I'm running my reference one with two boards enabled so I can run it on a 120 volt power line. Two boards using stock firmware results in about 9th speed at slushpool with 1,000 watts being pulled at the power plug. Which oddly enough seems to be about the same as running three boards in "low power mode". Go figure.
Title: Re: ANTMINER S9 How to off two hashboard ??? Post by: Artemis3 on December 23, 2019, 01:30:39 AM I try this earlier :( This is don work :( The Antminer cannot connect to the pool,when the cable of 2 hashboard a turn off Do you have any idea ? The S9 miners do not need all three boards, a single board works. You have another problem. Of course two boards also work. Title: Re: ANTMINER S9 How to off two hashboard ??? Post by: philipma1957 on December 23, 2019, 04:04:08 AM I have 27 s9 units.
three boards. 23 two boards. 3 one boards. 1 they work. so your issue is something else. load some views of the logs. also what model also what firmware? |