Title: Whatsminer M10 PSU Trouble Post by: welderminer on May 31, 2021, 03:38:59 PM Hey so I have a Whatsminer M10 that would fire up and recognize the 3 boards, but only show chips on 2 boards and 0 chips on the third board.
I checked voltage across the 2 pole connectors from the PSU and it read 14 volts. As I was checking, the small cover with the control board slid down and contacted both pole connectors at the same time. The machine shut down or went into what I thought might be protection mode. I killed the power and waited 10 minutes, then fired it back up. An error code 210 showed up, and now there is 0 volts between the pole connectors. I disassembled and checked the PSU and can't find a fuse inside that might have blown, other than the one main fuse where the power comes in. When I refresh the screen on the main miner control panel on my computer it won't read anything over 1s either. Is there something I should look for, or has anyone else experienced this? Makes me very nervous since it's impossible to find spare parts right now. Maybe someone knows where I can find parts these days? Any help or advice would be greatly appreciated, thanks in advance. Title: Re: Whatsminer M10 PSU Trouble Post by: BitMaxz on May 31, 2021, 05:08:09 PM If you are looking for parts try to check this
- https://www.zeusbtc.com/Repair.asp You can also contact them directly and maybe they can give you some parts needed for your M10 PSU. Can you share the exact model of your PSU? I will try to use it as a keyword to find the service manual for that model through Google. I suspected there might be a short diode or mosfet that might cause no voltage output Title: Re: Whatsminer M10 PSU Trouble Post by: welderminer on May 31, 2021, 08:31:28 PM Hey thanks for the reply, I have looked on their site and tried contacting them, and will continue to do so.
It's a Whatspower P11. |