Title: Metal Stand Blueprint for asics? Post by: tvsm22 on August 17, 2021, 01:33:06 PM Hellow. I want to make a metal stand for my asics and maybe someone have some kind of a blueprint, or simple drafts of such a stand?
Want to make good looking and usefull. Please help ::) Have all the needed equipment to make from metal - rolling, cutting, even painting oven :-) Title: Re: Metal Stand Blueprint for asics? Post by: jackg on August 17, 2021, 01:55:22 PM You might want to move this to the mining board to get more of an input for what active miners are using - the move button is at the bottom left.
I've seen a lot of people use just normal shelving units you can find in most places (like the ones shops use) but a lot of them seem to have slats in them to allow for better air flow. Title: Re: Metal Stand Blueprint for asics? Post by: BitMaxz on August 17, 2021, 02:29:37 PM I couldn't find any blueprint but why not make simple as this design below?
You can use this as your reference. https://i.imgur.com/4qADPZJ.png Then look at this https://i.imgur.com/sKVuzCK.png Title: Re: Metal Stand Blueprint for asics? Post by: crwth on August 17, 2021, 03:47:24 PM Why not use a good dissipater of heat? Probably not fully metal frame but a ceramic tabletop that could have better thermal conductivity and can resist high temperature that could damage the table in the long run.
I don't think you need a special blueprint, just possibly a plan on how you will set up your Asics and how many will be placed on a single layer, etc. Reverse engineer it and then make the necessary measurements. |