|
Title: Innosilicon A4 Debugging Post by: IronSheepman on September 04, 2021, 01:53:20 PM Can someone answer a few basic Innosilicon A4 hardware debugging questions:
1) Can you switch Hashboards in within a miner without harming/effecting mining? 2) Can you replace a bad hashboard from another miner (same model) without problem, or do you have to match a Hasboard ID# printed on the board (if so where do you find it) 3) If a hashboard doesn't Light-up, is the problem in the hashboard, in the controller, or potentially in either? Title: Re: Innosilicon A4 Debugging Post by: ncsupanda on September 27, 2021, 04:01:07 PM Use InnoMonitor to get the error message code/explanations.
I dont know the answer for the other two specifically for Inno devices. If from the same batch I've never had issues w/ swapping. |