Title: cgminer command line for 3 Workers Post by: Cas1m1r on April 19, 2022, 12:35:22 AM To start my bitcoin mining experience I have purchased the bitcoin merchant 3x Gekko Compac F combo with Raspberry Pi 4 preinstalled with cgminer. I want to set each mining stick as a different worker on slushpool. I enter the following terminal commands:
cd git/vthoang/cgminer sudo ./cgminer -o stratum+tcp://us-east.stratum.slushpool.com:3333 u myacctname.palermo1 Terminal responds showing 3 chips ramping up to 200-300 h/s each Switching to slushpool shows one Worker named palermo1, status OK ramping up to 302.8 GH/s scoring hashrate. This appears to be only one chip working??? All three sticks are blinking and working minimal heat. How do I change my code to get three workers running around 300 GH/s each? Help appreciated as I am having difficulty learning to do this. Cas1m1r Title: Re: cgminer command line for 3 Workers Post by: BitMaxz on April 19, 2022, 11:46:36 PM Maybe you will need to overclock them I check the cgminer command you can adjust the frequency of this USB stick. Read the command line below
Code: --compac-freq <arg> Set GekkoScience Compac frequency in MHz, range 100-500 (default: 150.0) Or if not then try to seek help from this official thread below don't forget to read the first page there are some commands that I think you can try. - https://bitcointalk.org/index.php?topic=1173963.0 Also read all commands here http://ck.kolivas.org/apps/cgminer/ Title: Re: cgminer command line for 3 Workers Post by: NotFuzzyWarm on April 22, 2022, 08:24:14 PM The OP mentions that he is trying to run the Compac F - you need the latest cgminer build from Kano to run them because -vh's versions do not have the ASIC chip driver needed and of course -ck's outdated versions do not either. https://github.com/kanoi/cgminer
Home thread for the Compac Ferrari is https://bitcointalk.org/index.php?topic=5355470.msg57735149#msg57735149 that is also where you find the installation instructions. Use the link in the opening post there to jump to the install instructions and suggested running commands. |