Title: hydro miner temperature threshold Post by: rjavadi on July 27, 2024, 07:37:04 AM Hi,
I need to play with S19 hydro miner temperature threshold setting at my own risk. Currently it starts mining when inlet water temperature exceeds 20c. I need to set it to lower value to resolve startup period. I am operating a hydro power station where its input water temperature is only 10c. After miner gets started its hot output water is combined with input water to satisfy the desired temperature range. Regards. Title: Re: hydro miner temperature threshold Post by: BitMaxz on July 27, 2024, 12:07:50 PM I don't think you can play temp threshold for s19 hydro it only has 3 options to choose from sleep, normal, and high-performance mode and this unit won't run if the unit is below 20c or if chip outlet temp exceeds to 80c it will stop mining with fatal error on the logs.
If you want to do some experiments about the temp limit, then you will need another OS like Braiins. Since this unit is supported, you can try it by downloading the firmware from this link below and boot it with an SD card. - https://braiins.com/os-firmware/download Title: Re: hydro miner temperature threshold Post by: NotFuzzyWarm on July 27, 2024, 04:49:19 PM Get a small electric water heater, put it inline with the miner(s) and use it to preheat the water until the miner is operating and can take over for it.
Title: Re: hydro miner temperature threshold Post by: darkangel11 on July 27, 2024, 08:04:26 PM Get a small electric water heater, put it inline with the miner(s) and use it to preheat the water until the miner is operating and can take over for it. It can be done even easier than that. These miners have water reservoirs and you can put a heating cable, like the one they use in floor heating, in there. The cable costs a few bucks and is perfect for increasing temps by a few degrees. It's strange that they set it to 20. I agree that 80 for cooling water temp is too high because at this point it's already starting to vaporize, but 20 for starting temp seems a bit high. What if you're trying to run this in your basement in winter. It's going to be 10 in there, so we could say a perfect temperature for mining, but these guys won't start, despite it being perfectly safe temperature for servers, but not for miners? Title: Re: hydro miner temperature threshold Post by: NotFuzzyWarm on July 28, 2024, 02:34:24 AM Get a small electric water heater, put it inline with the miner(s) and use it to preheat the water until the miner is operating and can take over for it. ...It's strange that they set it to 20. I agree that 80 for cooling water temp is too high because at this point it's already starting to vaporize, but 20 for starting temp seems a bit high. What if you're trying to run this in your basement in winter. It's going to be 10 in there, so we could say a perfect temperature for mining, but these guys won't start, despite it being perfectly safe temperature for servers, but not for miners? The same applies to fluid cooled miners but because of the highly efficient liquid cooling it is impractical to do a warmup phase - it would just take too long to get the cooling system up to temperature. Mfgrs did not change the circuits to run at lower temps because doing so then screws up the high temp operation. Since the amount of heat transfer between is proportional to the ΔT between the fluid and ambient air temp and since some areas can get up to >40C it is far better and easier to just keep the miners designed for high chip temps to minimize the size of the radiators needed. In short - the miners rely on warm fluid temps that are at least comfortable room temp and up to very warm (as in desert hot), NOT cold water. |