|
Title: CPUMINER and G-Blade problem Post by: SUGO on May 12, 2014, 07:23:11 PM I have a rig with a g-blade and 7 gridseed. I tried for first time CPUminer, but after a couple on minute an half of g-blade don't show any accept or reject lines (coloured lines)... It show only white string il loop:
New job id ... Stratum detec new block Dispathcing newwork on... It means it not mining right? But the question is: why? I divide thw works in 3 session of cpuminer (one for the 7 gridseed an 2 for the 2 half gblade), and only an half of gblade give this error (with all frequency set) I'm using cpuminer beacouse is the only miner with autoclock, right? Or there are some others? The problem is beacouse the 2 half gblade must run both? Title: Re: CPUMINER and G-Blade problem Post by: kingscrown on May 18, 2014, 03:43:03 AM http://fuk.io/gridseed-g-blade-vs-gawminers-cloud-hosting-comparision-and-review/
check my guide Title: Re: CPUMINER and G-Blade problem Post by: coincidenter on May 18, 2014, 04:42:13 AM I had a similar issue running cgminer on Windows 8.1. Not sure it's the same thing you're seeing, but this is what fixed it for me:
1. Disconnect your GridSeed Blade USB from your computer. 2. Run cgminer (or in your case cpuminer). 3. Plug the USB back in. 4. Wait a few seconds and you should start to see the usual accepted/rejected lines. I'm assuming you did the Zadig WinUSB driver install step before all this. Title: Re: CPUMINER and G-Blade problem Post by: sandor111 on May 19, 2014, 01:27:10 PM I have a rig with a g-blade and 7 gridseed. I tried for first time CPUminer, but after a couple on minute an half of g-blade don't show any accept or reject lines (coloured lines)... It show only white string il loop: New job id ... Stratum detec new block Dispathcing newwork on... It means it not mining right? But the question is: why? I divide thw works in 3 session of cpuminer (one for the 7 gridseed an 2 for the 2 half gblade), and only an half of gblade give this error (with all frequency set) I'm using cpuminer beacouse is the only miner with autoclock, right? Or there are some others? The problem is beacouse the 2 half gblade must run both? Make sure that you are running the latest version (1.0d), apparently this issue has been fixed lately. https://github.com/siklon/cpuminer-gc3355/ |