Bitcoin Forum

SOLD. 

i have a gridseed blade that was overclocked, was getting close to 7mh/s on it.  has a short, live-wire was plugged in, and it stopped working properly.  it won't hash or detect.  when i plug in the power the fans spins, but that's about it.  The device is not acknowledged by the USB...it is not detected.  the device itself is in pretty good condition.  i don't really have the skill set to determine if it's a fried resistor, or if it has an FTDI chip like old BFL asics that may have gotten fried, hence it does not detect.  The pcb looks pretty good, i cannot see anything burnt.

Make me an offer (keep in mind you pay shipping also)  

no cables or psu will be included, but it will include the 3 extra fans.  Thanks


Pic 1 Front of GS.  i have 3 extra fans for cooling.  it was an overclocked unit.  fans were soldered onto pcb.

http://s30.postimg.org/i0uzjj88t/4_front.jpg (http://postimg.org/image/i0uzjj88t/)

Pic 2 Shows entire PCB from above

http://s10.postimg.org/wtvy9zns5/3_above.jpg (http://postimg.org/image/wtvy9zns5/)

Pic 3 is view of where the live wire connection happened.

http://s1.postimg.org/6ndpr2aaz/image.jpg (http://postimg.org/image/6ndpr2aaz/)

Pic 4 back of the pcb, right below barrel jack.  

http://s27.postimg.org/dhuoxhj8f/image.jpg (http://postimg.org/image/dhuoxhj8f/)

I'll take it if you can send it for cheap.
I'll only need the PCB, so it could save some price on shipping too.

i am sending you a PM now.

I was faster  ;D