|
Title: Just Got New Hardware Post by: AJinNYC on December 22, 2014, 05:34:41 AM A couple of questions on some new hardware I just got.
I got a Rockminer "New" RBox. It's running fine. Red power led is on, and the blue status led is blinking. Is it not supposed to run at 110 GH/s? I'm only getting about 77GH/s, ideas on why? I'm running it through a USB 2.0 hub. I didn't install drivers on it. I just hooked it up and opened MultiMiner, and it found it without a problem. Maybe it's using drivers for something else? Second, I got an S3+, regarding powering it, should I be using two cables on my PSU for it, or would one cable (with two connectors) work? Title: Re: Just Got New Hardware Post by: Zich on December 22, 2014, 06:23:37 AM ..... Second, I got an S3+, regarding powering it, should I be using two cables on my PSU for it, or would one cable (with two connectors) work? Yes, you should use two cable from psu, one cable is not enough. Title: Re: Just Got New Hardware Post by: dogie on December 22, 2014, 06:34:00 AM Check you've followed through the setup steps in my sig for the New R-Box although I expect your multiminer is running an old version of cgminer. Stock speed is 100GH.
Title: Re: Just Got New Hardware Post by: AJinNYC on December 23, 2014, 12:57:34 AM Thought I would share a few pics of the rig now that it's mostly functioning.
http://cdn2.aspyr.us/imgs/rig1.jpg http://cdn2.aspyr.us/imgs/rig2.jpg |
