Title: LED config on a TP-Link tp-703n running nwoolls firmware Post by: bbOOmm on February 07, 2015, 09:52:10 PM ???
I'm stumped. I have a TP Link tp-703n router that has been re-flashed with NWoolls v4.5.0-r1 firmware. There is no GUI due to the limited RAM onboard the tp-703n so everything is done via ssh or serial so its not as easy as ticking a couple boxes and clicking save/apply. I have managed to get bfgminer running automatically on boot but I have one more thing I would like to have. I would like to have the tp-link:blue:system LED set to netdev for rx and tx activity currently the LED is off below is the /etc/init.d/led contents.... I'm hardly a programmer, I'm more of a "lets see what this does" person... which I usually learn from my mistakes, but this has me stumped. If someone could make the appropriate changes to the /etc/init.d/led file and post it in the comments here, I'd greatly appreciate it. Maybe highlight the changed so I can see what was changed and learn. Thanks ---------------------------------------------------------------------------------- Code: #!/bin/sh /etc/rc.common Title: Re: LED config on a TP-Link tp-703n running nwoolls firmware Post by: bbOOmm on February 07, 2015, 09:59:57 PM ALSO ... I have a stack of books here like "Learning the Bash Shell", "DNS and Bind", "Learning PERL", "Advanced PERL Programming", "PERL for system administration", "Learning the Vi editor", "PHP and MYSQL" .... and LOTS MORE. I probably have a book on the topic that would cover editing init.d files, but I'm confused where to look.
this /etc/init.d file editing, what or where should I look? What language is the init.d files in? Thanks |