Title: Help with Bfg miner, or USB miner stick or website? Don't know yet Post by: yunfun123 on March 12, 2015, 11:47:27 PM Hello, as you can see my miner is hashing, but can't get to the network I think? The main error is that annoying
"Error Trying to wake Notifier error" Along with the Hiding blocks from pool, but Ive had it working before, and now I can't get it to work anymore? Picture of my Cmd Prompt: http://s10.postimg.org/cha9b22ah/help.jpg And this is my batch cmd line I am running: bfgminer -o stratum.btcguild.com:3333 -u yunfun123_1 -p any -S \\.\COM4 pause .. Any suggestions Would be appreciated!! Happy Mining Title: Re: Help with Bfg miner, or USB miner stick or website? Don't know yet Post by: CryptoCanary on March 13, 2015, 02:44:44 AM Some pools I have mined with I see the "... hiding block contents from us" often. But, shares get accepted however so, I think its safe to ignore that one. The wake notifier error I have not seen. hhmmmm...
I see you have a low hash rate. Maybe you just have not waited long enough for a share to get accepted...??? Maybe on the pool you could change the worker's difficulty to 16. Maybe try your "bfgminer -o strat....." directly from a command prompt. Bypassing your .bat and the pause. "pause" and "can't wake" might be related ;) I am grasping maybe but, just a thought. Worth a shot perhaps. :) Title: Re: Help with Bfg miner, or USB miner stick or website? Don't know yet Post by: Zich on March 13, 2015, 11:46:54 AM It's seem running normally. Since the hashrate very low, there is no accepted share yet.
Title: Re: Help with Bfg miner, or USB miner stick or website? Don't know yet Post by: yunfun123 on March 14, 2015, 04:57:17 PM The reason the Hash is low, is because I just plugged it in to get the message to show you guys, the normal Hash rate is running at 333 MHz, just like its supposed too via the specs. Also, I noticed on the pool that I was mining on, was before I would see my miner mining on the dashboard of site and see acct balance go up. I ran it for an hour yesterday with the same error messages, and it went up ever so slightly???
The absolute weirdest part, was before I reformatted and right after I reformated it worked with no problems, and now in the past days these error messages?? @CryptoCanary, How do I do this with my batch file? Maybe on the pool you could change the worker's difficulty to 16.? -Diff 16 ? Also, I will try to run it without the pause cmd, and straight from cmd prompt and let you know what happens. Thanks for the Replies !! Happy Mining Title: Re: Help with Bfg miner, or USB miner stick or website? Don't know yet Post by: yunfun123 on March 14, 2015, 05:31:38 PM http://s9.postimg.org/z2vlfa673/Untitled1.png
I THINK WE ARE GOOD :) I removed the pause from my batch file.. Damn whoo knew right, Great Idea CryptoCanary Thanks!! AND HAPPY MINING! |