Title: CM1 alternative uses...? Post by: Cranky4u on September 06, 2012, 12:46:38 AM I am looking at broadening the use of my CM1s and am looking for suggestions which already have software / bitstreams available. I am thinking along the lines of;
1. MATLAB co-processor support 2. Rendering support 3. Simulation support (plastic flow extraction models, heat transfer modelling, etc...) 4. Cryptographic support (password recovery, strength analysis) Ideally, any ideas that can turn a few bucks....so as to de-risk my investments. Thanks for the leads in advance. Cranky. Title: Re: CM1 alternative uses...? Post by: ShadesOfMarble on September 07, 2012, 02:10:20 PM I think the main problem is to have a working bitstream for a given task. If you look at the CM1 development, the bitstream was (is?) the biggest issue.
Title: Re: CM1 alternative uses...? Post by: Cranky4u on September 09, 2012, 05:28:56 AM yep...looking for bitsreams for xilinx 150s as per CM1 boards...combining this for some hardware specific acceleration to increase commercial rendering times from days to a few hours then offer that as a service.
|