|
Title: Solo mining sanity check Post by: Freakin on June 15, 2011, 03:21:28 PM Just wanted to make sure I'm doing this right for solo mining backup
Start the daemon, set RPC username/password, allowed IP range and port number. Use phoenix to connect to localhost with those parameters. I should be seeing "Result didn't meet full difficulty, not sending" until I generate a block, at which point it will be "accepted" and reflected directly in my balance. Is that correct? Title: Re: Solo mining sanity check Post by: benx009 on June 15, 2011, 04:28:13 PM Has your bitcoin client caught up with the block chain? I think that needs to happen for solo mining... could be wrong though, or you may have already accomplished that step.
Title: Re: Solo mining sanity check Post by: Freakin on June 15, 2011, 04:32:55 PM Has your bitcoin client caught up with the block chain? I think that needs to happen for solo mining... could be wrong though, or you may have already accomplished that step. yes. Block chain is current. Running a getinfo reports accurate results. Title: Re: Solo mining sanity check Post by: benx009 on June 15, 2011, 04:53:26 PM You should be good then, afaik.
|