Title: CGminer autoreconnect to primary? Post by: Ladukas on February 06, 2014, 05:28:51 PM Hey guys.
Is there any simple solution how to make cgminer reconnect to primary pool from fail-over pool if primary is up again? Let's say, primary pool failed, back-up pool is used. Does cgminer check whether primary is online and does it switch the pool back? Thanks! Title: Re: CGminer autoreconnect to primary? Post by: -ck on February 06, 2014, 10:05:41 PM Yes it's supposed to go back in failover mode.
Title: Re: CGminer autoreconnect to primary? Post by: Ladukas on February 07, 2014, 06:54:25 AM Yes it's supposed to go back in failover mode. Hi, thanks for your reply. Are you talking about --failover-only or the pools which I list in config file? Is there any way to put failover-only into config file or the only way is to put this command into the .bat file? Cheers. Title: Re: CGminer autoreconnect to primary? Post by: HellDiverUK on February 07, 2014, 08:55:41 AM Yes it's supposed to go back in failover mode. Yes, it is, isn't it? Except quite often it never does, it just sits thee like a twat mining on the backup pool. I see the same problem on 3.11.0 on Linux and on the dodgy patched 3.11.0 for the HEX16A2 on OpenWRT. |