ok finally i got 3 cubes working.. but 2 do not.
my 3 cubes mine this:
so how ot reunf 2 other cubes or what should i do?
I got two dud comms cables, so check your cables.
Replace one of the working cubes with one of the non-working cubes - make sure you use the same controller cable that was working (use the same power supply and PCIe cable(s) too, just to be sure). If it works, the cable (or controller port) is faulty. You can check each controller port by using a known good cable and known good cube on each port in succession (powering down and rebooting each time). Yes it is a pain, but you have to try every combination in order to find which component is at fault.
Hopefully it is the cables. I asked KnC to send me three more and they did (I asked for one more than I needed, just in case)
Thanx. So after playing with this alot it seems you have to push really hard [more than you should] those pins i nthe miner. Now it sees all 5 cubes BUT:
2 of them stay at 50mhz instead of 475mhz no matter what i do. Also i cannot enter the 'advanced' part on the system - it justn ever goes there.
Any ideas what i can do?