So I got a fan to test that has a maximum CFM of 85.6
Do you think that will be enough airflow?

Does anyone know what CFM the default fans do?

Thanks,

Transactions have been friendly and honest

Let's hope we have 6 months of trouble free mining

Payment has been made

TXID is

761682de67daa3c51e96e1025d54a70942f9d06510e8e0eb881d64eab54d480f

Thanks,

Hi,

I'd like to buy 36 Shares (1 Antminer)
Could I please have a unique address?

Thanks,

Hi All,

I have 3 Antminer S1's running in conjunction and they are getting a bit loud
Unfortunately I have no where else to put them in a living area no matter where you go you can hear them

Has anyone successfully changed to fans that were quieter?
If so do they push the same airflow through as the stock ones?

A question as well I noticed both fan connections are the 4 PIN PWM type but the pins are quite close to the edge
I've been looking through a lot of fans and its very rare to find one with this connection.. even an adapter is hard to find

My second question would be if I just replaced the fans with a case fan (normal molex connection)
Would the unit freak out that it had no fans connected and not turn on?

Hopefully someone can  help

Thanks,

Hi,

Interested in the reason for selling these?
I have a few and they are running fine and are still profitable..

Are you in the US as well?

So continuing on with my errors..

I know my HW error rate is acceptable on the unit in question
But my other two units have green lights on under the LAN connector and the one with the HW error doesn't have it on

They are all mining at 180GHS but is it something I should be worried about?
I think it may not be reading the fan/temp properly? The fan is always 400 rpm more than the other units

Thanks,

It doesn't line up properly but the HW error is 6407
What number are you comparing that to to get 0.297% ?

Hi,

I was hoping someone might be able to help
I'm currently running 3 x 180GHs Antminer S1's

They are all stock I haven't touched any of the settings on any of them
1 unit though is getting a lot of HW Errors and the Fan isn't spinning up as fast as the other two (although it's still reading roughly the same temp - 48-49C)

I've tried 3 different power supplies and it does the same on all 3
My other two have 0 HW errors and their fans are running at 2600+ rpm

Elapsed   GH/S(5s)   GH/S(avg)   FoundBlocks    Getworks   Accepted   Rejected   HW   Utility        Discarded   Stale      LocalWork   WU         DiffA             DiffR     DiffS   BestShare
14h 33m    5s183.55      178.74           0                1,941        16,740         63        6,407    19           3,349          13       2,660,070       2,497       2,142,720      8,064        1664          8,670,781

Chain#   ASIC#   Frequency   Fan   Temp   ASIC status
1                32              350        2280    48   oooooooo oooooooo oooooooo oooooooo
2                32              350          0       50   oooooooo oooooooo oooooooo oooooooo

Any idea what I can do for this one?

Thanks,