Show Posts
|
Pages: « 1 [2] 3 4 5 »
|
Can anyone confirm that they have received the airdrops and those cleared with confirmations?
Thank you BTC3
no airdrop yet for my wallet 34BJqYgtxo8RuhDsw9F641afXwLd5CTSNH Just sent some, please check Thank you
|
|
|
cryptohamstr.com it is not a working pool but rather a fraudulent one since payments from it do not go
The pool requires more than 50 confirmations, so give it some more time and payouts will be working. This i no p2p pool where you get payed as soon as a block is mined. I did check the backend and there are no payouts yet. After doing a manually "sendtoaddress" test i receive the following info on the console: "error -4: fee estimation failed. fallbackfee is disabled. wait a few blocks or enable -fallbackfee." I remember that this also happened on BitcoinSV so i think in general we need to wait a bit more. I did put some hashing power on the pool in order to get more new blocks. I will look for the error again in a few hours. The pool has a "history" for all addresses mining Bitcoin3. So if the automatic payout wont pick up i will enable "fallbackfee" on the wallet and/or do manually payouts for the miners. As for the next "check" i will have a look on March 27, 2021, 04:30:00 PM forum time current time is March 27, 2021, 02:18:27 PM so i will post again in 2h. *edit* I did PM the DEV and told him about the error. In worst case i will manually payout the unpaid balance Total Paid 2087.25000000 BTC3 but nothing made it to wallet so should I just wait or go back hashing Can you PM me your BTC3 address? So i will have a look for you, but i am quite sure that there is no TX ID for your payout so i can do a manual payout, this should be working. If there are any payout problems or any other issues, i will have a look and work on a solution 3QRwN5wm3sVKSfdB6x82tbJEnuoqGFeAxq Sent you some btc3 please confirm once it gets confirmed by the network on your end. Thank you
|
|
|
Can anyone confirm that they have received the airdrops and those cleared with confirmations?
Thank you BTC3
|
|
|
You can get the nodes my pool is currently conencted too. Only 3 connections so far but it should have more connected nodes in a few days. https://cryptohamstr.com/explorerClick on the, currently red, 3 to get all the connected nodes. This is also working for other coins on the pool. Hi, Please post your BTC3 address here. Would love to send you some coins for all your hard work. Thank you BTC3
|
|
|
Standing by for cryptohamtr pool to come online so we can start test mining.
|
|
|
When will the v1.0.2 wallet be released?
Hi, The new source code is already on github available for download. Thank you BTC3
|
|
|
Just sent some workers here http://121.196.121.176/statsCan the pool operator verify that it's online? Miner's seeing it as offline. Thank you BTC3
|
|
|
Pull request has been approved and merged on github.
Thank you BTC3
Thanks for the hard work. And we can say BTC3 is now anti-freeze blockchain against high hash attacks. So are we going to get v1.0.2 releases soon? I think just can compile from the source: https://github.com/Bitcoin3-source/Bitcoin3.0Thanks. Yes people can just compile from the source from github. Thanks BTC3
|
|
|
New mining pool active First block has been found cryptohamstr.com
1% pool fee stratum: -a scrypt -o stratum+tcp://stratum.cryptohamstr.com:3333-u ADDR -p c=BTC3 You can use c=BTC3,D=X in order to change your miners difficulty. Have fun mining. *edit* The pool is currently on block 1 842, is this the right chain? We are on the way to change to use v1.0.2. Need to confirm from the dev. https://github.com/Bitcoin3-source/Bitcoin3.0/pull/1We already have someone confirming the pull request and just reviewing the new code. Thanks BTC3 when will the network start working? where to download the wallet v1.0.2? The network is working, its just that we have to mine the stale blocks left behind by that one miner that had massive mining power until the chain re-targets the diff ratings. At the moment we are not yet recommending the v1.0.2 until we can verify the code with the pull request on github. The network is not stuck, rather we are mining with a current diff rating of 39M already going down from 158.644M on https://cryptohamstr.com/explorer which was mined for several blocks with somewhere around 5PH/s of mining power. Blocks 1845 Connections 17 Difficulty 39661041.268316 Networkhashps 10775809367397 == 10++GH/s Thanks BTC3 Actually when last time the block was stuck at 1841 the difficulty was 73317394.167 (which was highest): #1841 73M And after 4 blocks found from cryptohamstr.com, it's down to 39661041.268: #1845 39M And now stuck at even higher difficulty 158644165.073 #1846 158M <--- stuck here for 26 hours So we need to protect BTC3 from malicious outsiders ruining BTC3 as well as from the skyrocketing difficulty changes from normal mining. Waiting for the new release soon! Pull request has been approved and merged on github. Thank you BTC3
|
|
|
New mining pool active First block has been found cryptohamstr.com
1% pool fee stratum: -a scrypt -o stratum+tcp://stratum.cryptohamstr.com:3333-u ADDR -p c=BTC3 You can use c=BTC3,D=X in order to change your miners difficulty. Have fun mining. *edit* The pool is currently on block 1 842, is this the right chain? We are on the way to change to use v1.0.2. Need to confirm from the dev. https://github.com/Bitcoin3-source/Bitcoin3.0/pull/1We already have someone confirming the pull request and just reviewing the new code. Thanks BTC3 when will the network start working? where to download the wallet v1.0.2? The network is working, its just that we have to mine the stale blocks left behind by that one miner that had massive mining power until the chain re-targets the diff ratings. At the moment we are not yet recommending the v1.0.2 until we can verify the code with the pull request on github. The network is not stuck, rather we are mining with a current diff rating of 39M already going down from 158.644M on https://cryptohamstr.com/explorer which was mined for several blocks with somewhere around 5PH/s of mining power. Blocks 1845 Connections 17 Difficulty 39661041.268316 Networkhashps 10775809367397 == 10++GH/s Thanks BTC3 where can I get the list of nodes It’s dead,,, out of sync. It’s been 9 hours
Mine works just fine. If your knowledge is in baby shoes, maybe you really need to stop posting and make you look like an total idiot. Anyone have problems of wallet 9 hours behind and syncing headers 94% its stuck
Add these to your conf file and restart the client addnode=136.144.171.201:30268 addnode= 158.101.29.12:30268 addnode=95.11.228.167:30268
|
|
|
New mining pool active First block has been found cryptohamstr.com
1% pool fee stratum: -a scrypt -o stratum+tcp://stratum.cryptohamstr.com:3333-u ADDR -p c=BTC3 You can use c=BTC3,D=X in order to change your miners difficulty. Have fun mining. *edit* The pool is currently on block 1 842, is this the right chain? We are on the way to change to use v1.0.2. Need to confirm from the dev. https://github.com/Bitcoin3-source/Bitcoin3.0/pull/1We already have someone confirming the pull request and just reviewing the new code. Thanks BTC3 when will the network start working? where to download the wallet v1.0.2? The network is working, its just that we have to mine the stale blocks left behind by that one miner that had massive mining power until the chain re-targets the diff ratings. At the moment we are not yet recommending the v1.0.2 until we can verify the code with the pull request on github. The network is not stuck, rather we are mining with a current diff rating of 39M already going down from 158.644M on https://cryptohamstr.com/explorer which was mined for several blocks with somewhere around 5PH/s of mining power. Blocks 1845 Connections 17 Difficulty 39661041.268316 Networkhashps 10775809367397 == 10++GH/s Thanks BTC3
|
|
|
New mining pool active First block has been found cryptohamstr.com
1% pool fee stratum: -a scrypt -o stratum+tcp://stratum.cryptohamstr.com:3333-u ADDR -p c=BTC3 You can use c=BTC3,D=X in order to change your miners difficulty. Have fun mining. *edit* The pool is currently on block 1 842, is this the right chain? We are on the way to change to use v1.0.2. Need to confirm from the dev. https://github.com/Bitcoin3-source/Bitcoin3.0/pull/1We already have someone confirming the pull request and just reviewing the new code. Thanks BTC3
|
|
|
What is wrong with the original source? Difficulty got stuck too high?
It was an attack I believe and will happen again unless BTC3 is prepared to overcome. We don't that yet for sure but if it was then then miner that left us with massive diff rating is long gone and we are left to mine several stale blocks to make the chain re-target to a lower diff rating commensurate with the current hash power.
|
|
|
Contemplating on sending some asic miners on the pool http://121.196.121.176/getting_started before the end of the week if the mining doesn't pick up speed. Someone with massive hashing power mined btc3 to bump up the diff then left.
|
|
|
Hoping that dev accepts my pull request, I've upgraded the seed node 158.101.29.12 to use v1.0.2. I think it's better than just waiting on the stale chain. https://github.com/Bitcoin3-source/Bitcoin3.0/pull/1Anyone to wait for dev further, feel free to use new version. Sorry I cannot compile and push so you have to compile. Hi there, Apologies been away for a couple of days, had to deal with some natural disasters here where we live. We are working on getting your your updates to get pushed on github will pm you as soon as its done. thanks. Network got stuck due to someone using a lot of hashing power then leaving after a few blocks just to attack the network. Thank you BTC3
|
|
|
I now have 200 BTC3. How long until they are worth $50,000 each? Thanks Just hodl all you can :-)
|
|
|
Hello! I ran the file self_mine.bat but I get an error.
Make sure the bitcoin3d server is running and that you are connecting to the cor rect RPC port. error: Could not connect to the server 127.0.0.1:30267 (error code 1 - "EOF reac hed")
What could be the reason?
On the zip file there is a text file called 'Getting started' please read that and follow the instructions that is in there. Thank you
|
|
|
I am looking for github source but i can't find it, i would like to setup cryptohamstr.com pool. It would be great if you could send me the github link *edit* Just saw that you have precompiled wallet on your website, is there a source code? Hi, Any updates on coin listing on cryptohamstr.com Thank you BTC3
|
|
|
is there a blockexplorer coming É It would be very helpful to have an active node list so we could add some addnode= in our conf file. wallet still seems to stall out and is slow to reconnect sometimes
I guess we need more seed nodes to stabilise the network at the early stage. that would do it, I find deleting the roaming file (keep wallet.dat and Bitcoin3.conf) and restarting it fresh works to reconnect properly. I get a few mh with the pooler miner and have found a couple blocks We did have one more seed node a few days ago but has now gone offline, wonder who it was. :-) Agree, wee need more people to seed node the network. Thank you BTC3 You can spend team coins to reward those people who will keep the running nodes. Many projects do this. We need to get people interested in doing this. That is a good idea, also wouldn't any pools and a blockexplorer have a permanent nodeÉ as well if it gets listed on an exchangeÉ Graviex seems to like to list new coins We will look into it. Thanks for the suggestion. Thank you BTC3
|
|
|
is there a blockexplorer coming É It would be very helpful to have an active node list so we could add some addnode= in our conf file. wallet still seems to stall out and is slow to reconnect sometimes
I guess we need more seed nodes to stabilise the network at the early stage. that would do it, I find deleting the roaming file (keep wallet.dat and Bitcoin3.conf) and restarting it fresh works to reconnect properly. I get a few mh with the pooler miner and have found a couple blocks We did have one more seed node a few days ago but has now gone offline, wonder who it was. :-) Agree, wee need more people to seed node the network. Thank you BTC3 You can spend team coins to reward those people who will keep the running nodes. Many projects do this. We need to get people interested in doing this. Any party interested in doing this suggestion please send us a pm. Thank you BTC3
|
|
|
|