Ok, now I have all information and can explain everything here. Sorry for my bad English if you cannot understand what I mean.

At first, after block 40k, everything went wrong because of each wallet generated wrong chain itself and does not keep up with explorer and network -> many version of chain.

Few days after, Dev blinked in (very lazy dev, I am blamming you) and sync his checkpoint server with explorer (via my wallet). He also released fix version of wallet about the checkpoint. Then PoS was working smoothly for 1-2 hours til dev's crappy checkpoint server down again while he blinked out.

Today, dev gives MinerFTW checkpoint privatekey. The checkpoint server is stayed with MinerFTW and is working smoothly now and so on (will be). But fork again after few try because of many obsolete, wrong chain nodes are still out there, keeping "poising" each other.

Finally, MinerFTW found out, if we put the entry listen=0 to .conf file, the wallet connects to correct nodes only. To fix everything, follow my steps bellow:

Step 1: Download new wallet at first post

Step 2: Clean %appdata%\roamming\LiteDoge except wallet.dat (DO NOT DELETE WALLET.DAT IN ANY CASE)

Step 3: Create litedoge.conf and add bellow entries

Step 4: Run wallet and wait for synced up (should have 2 connections)

Step 5: Unlock wallet to begin stake

Good luck everyone!

Used these and got on a wrong fork

The fix seemed to be working for about an hour or two, then I forked again.  Confirmed I was on my own fork (and block explorer wasn't just laggy) by comparing block hashes on the explorer.  Cleared my appdata folder again and attempted to resync from scratch and now I can't connect to any nodes.

i have a chinese translation on the way, finally.

It is so great of you to have you around. Especially layer1gx. He is so wrong for the last Idonotknowhowlong that I know we will be fine as long as we do the exact opposite of what layer1fx states, advices etc. It gives me
An intense inner peace that I never experienced before.

Hey,

Sorry if this is a stupid question but I am more of an artist and not very technical. I have an old banksycoin wallet backed up as a .dat file on my memory stick. How do I run it as a program on my new laptop so that my old balance shows up on this computer? I have over 60,000 BSY so don't want to lose them now things seem to be taking off again. When I try and open dat file it says "this file is not supported"

Thanks 

Long time no c buddy, how are things there?

I would chip in with this as much as i can but at the time being i dont have much funds trading has been slow this year

He's super busy buying Doged at this great price!