 Show Posts
|
|
Pages: « 1 2 [3] 4 »
|
Hey, is this thread still alive? Is Aricoin still alive?
I attempted to make a deposit of Aricoin to my Aricoin Pay wallet, and it has not shown up. Did I make a mistake? Is the wallet no longer synced with the block chain?
AricoinPay uses the V2 wallet software running on separate blockchain. DON'T send between Aricoin V1 and V2 blockchains, it will not work. I will publish two more nodes, one for V1 and one for V2 later today. The wallet I used was your Aricoin wallet--the online one. I sent some coins in from Cryptopia. How was I supposed to know there are now two separate block chains or know to check whether exchange and wallet are both on the same one?  I don't have any admin rights at the moment to do anything. I am trying to negotiate with the team behind Aricoin about the future of this coin. If all works out I will make sure you will be compensated for the coins you lost by sending from one blockchain to another. |
|
|
|
I have connection, so I think there is just no mining going on to move the blockchain.
There is mining on both blockchains, Aricoin V1 and Aricoin V2. There are mining pools and you can also use solo mining with Aricoin since difficulty is low. |
|
|
|
Hey, is this thread still alive? Is Aricoin still alive?
I attempted to make a deposit of Aricoin to my Aricoin Pay wallet, and it has not shown up. Did I make a mistake? Is the wallet no longer synced with the block chain?
AricoinPay uses the V2 wallet software running on separate blockchain. DON'T send between Aricoin V1 and V2 blockchains, it will not work. I will publish two more nodes, one for V1 and one for V2 later today. |
|
|
|
|
I am a friend of the developer of this exchange and I have been beta-testing it for some time now. I really like this exchange and the fact that any bugs or problems I have reported has been solved. I trust the developer behind this exchange 100%.
|
|
|
|
@linusdunkers
That sounds really bad, man.
I checked your mining stats. Your recognized hashrate is jumping between 200 MH and 6000 MH from hour to hour. Your hashrate graphs look like a really bad sawtooth since 1 year!!. It was the same with old clevermining (CM1, old accounting, mining predominantly LTC) and did not change when CM2 (coin switching, new accounting) went live. You seem to have switched to the titan port 1 day ago. However, that just took your rejects down from 7% to about 2% (as expected). The jumping hashrate issue persisted.
Since the issue occurred on CM1, CM2 and did not happen to any other KNC miners on CM, i suppose that there might be a technical problem with your farm (can't connect to CM from time to time, switching to backup pools, hardware issues). In order to find the problem, it's a good idea to put your full farm on 2 other scrypt multipools, let it run for 24h each and check the recognized hashrate. If the hashrate is correctly recognized there, but not here, i am happy to do detailed debugging.
My miners are available for rental, so that is why you can see hashrate is going up and down a few times a day. But the main issue that I brought up in support ticket and on the forum is that 40% of the mining power was missing when I did a more deep investigation regarding my mining with CleverMining. That was not caused by any miner being rented and as soon as I posted my question and also changed the port and difficulty settings the hashrate became correct. So my question was, for how long time the old port and difficulty setting could have caused about 40% of the hashrate to disappear? |
|
|
|
@cleverming your Titan ports left something to be desired. I see bout 1.5-2% rejects. On prohashing.com(which switches coins much faster than your pool) I get about .7-1.5%
Also, it would be nice if the vardiff was statically set, because even if Im using 8192 ... bfgminer still dynamically changes diff while mining, sometimes vardiff goes so high the miner doesnt submit shares for blocks during fast rounds ... so I would lose out on that profitability.
Nice to meet the creator of the famous GenTarkin Mod  If you want to improve the Titan reject rate, you are putting Titans to coins with high difficulty and do less coin switching. That's to some point harming the profitability of other miners, which use well designed scrypt asics. 1.5-2% rejects is not too bad, if you think of overall scrypt profitability moving 20% up and down day by day. However, there is always room for improvement. I would need to have web access to a titan miner, in order to do intense testing for some hours on several days. Of course, i would compensate for the downtime. If you want to help and provide access to a titan, please PM me. Best, PPanther Well, like I said .. on prohashing the rejects are about half what I see on this pool and they switch coins MUCH faster than my Titan does on clevermining. Also, the other point is vardiff changes as I mine even when I set it statically to 8192. The problem is, vardiff will get set extremely high on fast switching coins and my Titan will only submit a couple shares ... and I lose out on profitability of those fast switching rounds. A place to start I think is to allow static vardiff of 8192 or higher and the pool shouldnt change it dynamically during mining. I just sent an email to your support (#27 Where goes the hashrate?) see copy below: Hello! You have great profitability according to your website. Currently 0.0001098 BTC/day per MH/s. I am running 20 x KnC Miner Titan units with a total hashrate about 6300 MH/s (according to BFGMiner stats). BFGMiner configuration: stratum+tcp://eu.clevermining.com:3333 <btc address> d=16384 Now, looking at the dashboard for this account: https://www.clevermining.com/users/<btc address> 3621.64 MH/S 8 min. accepted hashrate (252.78 MH/s rejected) WTF? Only 57% accepted hashrate compared to BFGMiner stats? It says 252.78 MH/s rejected, that is 4% out of the total current hashrate of 6300 MH/s. So where the fuck is the remaining 39%? The correct profitabililty is 0.000067 BTC/day per MH/s since you are not reporting hashrate correctly. I will take this information on the forum and you have to explain what you are doing and why. /Linus Dunkers (BTC Sweden) I am running the latest licensed version of GenTarkin’s Custom KNC Titan Firmware. I read some of the posts on this forum and I have now changed so that my miner configuration looks like this: stratum+tcp://eu.clevermining.com:3444/#xnsub#skipcbcheck <btc address> d=8192 The stats now are the following: 6067.76 MH/S 8 min. accepted hashrate (158.82 MH/s rejected) So could someone explain where the 39% of hashing power went before making these changes? I have been using CleverMining for more than a year. For how long time has about 40% of my hashing power gone to waste? /Linus Dunkers (BTC Sweden) |
|
|
|
Where can I buy these adapters? I have 10 x 2880W PSU to be used with 6 cube setups of KnC Miner Neptune and I would really need 10 adapters like this one. Hello,
are there any adapters/boards available which can power a KNC Titan (4-8x PCIe, 1600W + 1x5v Molex for Controller)?
Most boards "only" have connectors for PCIe, but I wouldn't like an extra PSU for the Controllerboard. Any suggestions?
Kind regards
And here are the first pics of the boards:   2x USB ports able to charge Iphone/pad/pod, Samsung,... at full speed Or simply power raspberries/beaglebone... 1x Molex HDD connector with a cable to power a KNC controller. The board is a pass through, so you can still use your PCI-E cable to power anything. Rated at 3A, over 92% efficiency for the voltage converter, you'll only draw 16w from your PSU if you manage to max out the USB ports and the Moles HDD plug. Price will be 19$ for the first batch, including one short PCI-E to PCI-E cable and one Molex HDD to Molex HDD cable. |
|
|
|
|
Is this pool gone forever of just temporarily?
|
|
|
|
The wallet is still synchronizing but estimated total blocks = 940937  The wallet is still synchronizing but estimated total blocks = 941244  |
|
|
|
How often does BFGMiner try to connect to primary pool while running on backup pool? I am using KnC Miner Titan units and on https://www.betarigs.com the pool is not reachable until someone rents your rig. I need to know how long it can take at most before the miners find the primary pool to be reachable and switches back to primary pool. |
|
|
|
|
Withdrawal of MTLMC doesn't seem to work. Have been waiting for about 15 hours, still saying "processing". Any support on this exchange?
|
|
|
|
This is probably the best mining pool I have tried I know the founder and developer who has a very pure interest and intention with this mining pool. Looking forward seeing more bitcoin services from you Jimmy |
|
|
|
|
Your site seems to be down at the moment...
|
|
|
|
|
I am still missing 8 million Aricoin (ARI) and half a bitcoin (BTC).
|
|
|
|
So far this exchange is acting 100% like a scam! They have not replied any of my messages and the deposits I made many hours ago still haven't shown up in my balances. Also suspicious trades happened only a few hours after the exchange opened the website...
their support email on OP doesnt work aswell WARNING! THIS SEEMS TO BE A SCAM! BE CAREFUL! https://twitter.com/Hash_NZ/status/528695305609310209 |
|
|
|
|
