We're still waiting to hear a response to our inquiry to them. Over a week ago now.

Spec wise we're probably looking at 28-30th/s at 1500ish draw. Looking at market could see a price range from $1.2k-2.2k. Most likely on the low end to compete with the T25.

Also the added tariff is 25%, for a total of 27.6% duty to the US.

Inspecting their page I couldn't find anything, then I'm not that good at it. I imagine it will be a pre order of some sort, just hope it isn't that long. S15 and T15 so two models next in series I imagine.

Well they announced on twitter two new models this week.

https://twitter.com/BITMAINtech/status/1059636075243524098

Where are you seeing the release?

Yea, just saw those myself wonder when we'll list them.

Has anyone tried to contact microbt? the email on their site get returned.

I saw the first post company link was not active. Is the .company address official? I read the thread but went back a fourth with no confirmation. Maybe I missed a post?

Yea, just pulled it out of the box, 14 6-pins.

One is extremely short so would have to use and extension.

Will look into splitters and extensions more.

---

https://www.newegg.com/Product/Product.aspx?Item=N82E16812706046&Description=6pin%20splitter&cm_re=6pin_splitter-_-12-706-046-_-Product

That was quick. Thoughts on this?

---

APW5 has 18 AWG cables so the split with the 16 I would imagine would be beneficial. (I did find the female/male version).

Looks like most extension are 18 AWG so any of those should do.

Looks like the plan killer.

Only 14. thanks for the eyes. I'll have to grab some psu's along with the pdu since ill be retiring the evga's to gpus full time now.

---

https://www.newegg.com/Product/Product.aspx?Item=N82E16812198016&Description=pcie%20splitter&cm_re=pcie_splitter-_-12-198-016-_-Product

forgot I have a few of these lying around. thoughts? Never used them on an asic before.

Well, we'll have to pull our S11 pre orders. . . oh wait.. . 

Thanks Styme.

My biggest concerns are start up draw as I'm looking at a switched pdu. Currently one we can source is with 16A outlets and is in my price range. I want to be able to start and stop these as needed. I run them -2 already but imagine start up draw is considerably more than HF has posted. Maybe I'm wrong?

Was interested in running two 821's with an APW5.  Spec looks like it should work, but imagine my pdu might be the bottle neck with just 12A outlets.

Looking at a new PDU with 16A outputs but hoping for some advice before the plunge.

Another way to save on their budget, reduce their cost on power use even if they get a sweet deal.

In your case JK you'll probably be ok with these, for others though these are losers unless you want to buy and hold till bull and be ready to power on. Then that takes risk and speculation that makes me uneasy to think about.

Then outside of stick miners, nice introductory units for hobbyists. 

There is a section for scams. Make a post there.

Scam.

I have this usb hub for my 2pacs, work fine. Maybe a zombie or two after a handful of days running.

I don't know seems like I addressed it.

People pay for follows, likes, share, etc. Their process sounds fishy, with a high margin for loss or scam. Good luck.

Hopefully there are new units coming. Imagine they're trying to soften the blow to their over forecast on budgeting still.